If you are installing a tape backup unit TBU , it must be installed in the second bay. Removing or Installing an Optional Diskette Drive. If you are installing a new 5. Although SCSI drives are installed in essentially the same way as other drives, their configuration requirements are different. SCSI interface connectors are keyed for correct insertion.
|Date Added:||5 March 2012|
|File Size:||28.94 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
If the hard is not included in a RAID configuration, go to step See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.
After you open and close the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next computer start-up:. If you are installing a tape backup unit TBUsc40 must be installed in the second bay. See ” Installing an Expansion Card ” in “Installing System Components” for instructions about installing the card and routing the cables.
To continue using , please upgrade your browser.
Although SCSI drives are installed in essentially the same way as other drives, their configuration requirements are different. SCSI devices poweredgs by Dell are configured correctly during the manufacturing process. To gain access to the front-panel insert, you might need to remove a device. To boot the system from a hard drive or drive array, the drive s must be connected to the appropriate controller:.
Removing or Installing an Optional Diskette Drive.
Drive Locations Inside the System. See the documentation provided with any optional SCSI drive you purchase for information on disabling termination.
When you disconnect an interface cable, take care to grasp the cable connector, rather than the cable itself, to avoid stress on the cable. The drive or device from which the system boots is determined by the boot order specified in the System Setup program.
SCSI logic requires that termination be enabled for the two drives at opposite ends of the SCSI chain and disabled for all drives in between. To install and configure a SCSI drive, follow the guidelines in the following subsections.
If you are installing a new 5. Keying ensures that the pin-1 wire in the cable connects to pin 1 in the connectors on both ends. For internal SCSI drives, termination is configured automatically.
Dell HC Dell GB U SCSI HP 15K w/9D [ 10 Pack ] Part# Dell -HCPack
SCSI interface connectors are keyed for correct insertion. For instructions, see the documentation that accompanied the drive. You can install an additional 5.